Electrical Surface Coating and Protection

Electrical Surface Coating and Protection

FlyArt - (M / H Voltage Power)

      Electrical systems may transform into an undesired conductive structure leading to adversities, electrical leakage, loss, or failure when exposed to external effects (i.e., dust, dirt, moisture, wetting). FlyArt electrical insulation spray is applied to the area or surface that needs to be insulated to obtain a bright, slippery and wetproof coating. This coating insulates all electrical surfaces for full protection.       

- It prevents corrosion, rusting, dusting and moisturization by breaking contact with atmospheric air.

- Prevents electrical arcs in transformers.

- Fully protects insulators, extending their service life, ensuring continuous operation.

- Protects electrical panels against external weather effects.

- It may be used in all types of industries, protecting all power and signal transmission components of electrical and electronic cards.

  This fast drying, flexible and transparent elastomeric coating is used for protecting electrical circuits. It is manufactured for professional use only and meets the requirements of most international standards.

  • It dries to a touchable finish in a noticeably short time, improving the efficiency of application processes at a low cost.
  • It maintains its transparency and high stability even when exposed to UV rays.
  • It provides a high level of protection in humid environments and it is resistant to molding.
  • It is capable of adhering to various substrates perfectly.

 

 

 

 

Instructions of Use:

      It can be applied by spraying, brushing, or dipping. Thickness of the coating might differ depending on the method of application (typically between 25-75 microns). This product should not be applied when the temperature is below  0°C or relative humidity is higher than 75%. An adequate quantity of product must be used as in all other solvent based protective coating products.   

     Clean the substrate thoroughly with FlyArt Electrical Surface Cleaning Spray before starting the coating process. This cleaning is essential for effective adhesion of the protective coating to the substrate. Furthermore, all residues should also be cleaned as they might cause wear if left on the substrate. 

Technical Data Sheet (TDS) 

 

PHYSICAL PROPERTIES OF THE PRODUCT  (LIQUID STATE)

Color

Crystal clear liquid

Volatile Organic Compounds  (VOC)

Contains volatile organic compounds (VOC )

Shelf Life

48 Months

Packaging

400 ML spray cans, 500 ML spray cans

 

PHYSICAL STRENGTH

 

Hardness Shore A

90 Shore A

Tensile Strength Mpa

4 Mpa

Elongation %

-

Service Temperature Range

-55 o to + 125 oC

Tear Resistance

Good

Adhesion

Perfect

Puncture Resistance

Perfect

Resistance to Hydrostatic Pressure

5 bars min.

 

 

RESISTANCE TO ENVIRONMENTAL FACTORS AND SERVICE LIFE

 

Water Resistance

Perfect

Resistance to oil, gasoline, and diesel fuel

Good

Ozone Resistance

Perfect

UV Resistance

Perfect

Vapor Resistance

Perfect

Alkali and Acid Resistance

Perfect

Superficial insulation resistance

1 x 1015 Ω

Dielectric Resistance:

45kV/mm

WhatsApp ile iletişime geç