FlyArt - (M / H Voltage Power) ELECTRICAL INSULATION and CLEANING AEROSOLS

FlyArt - (M / H Voltage Power) ELECTRICAL INSULATION and CLEANING AEROSOLS

FlyArt - (M / H Voltage Power) ELECTRICAL INSULATION and CLEANING AEROSOLS

Cleaning Aerosol:

This spray is specially formulated to remove impurities including but not limited to dirt, rust and remnants of lubricants that are formed on the circuit cards, panels, components, and auxiliary equipment used on electrical and electronic systems due to external weather conditions. It is possible to apply this product without cutting off the power thanks to its special structure that does not leave any residue or trace after use.      

-          In the electrical and electronic systems of all machinery operating under damp and humid conditions

-          On electronic cards and circuits of all  types of motor vehicles

-          In transformers

-          On the panels and circuits of power transmission lines

-          In all types of industrial sectors.

How to use:

Spray the product on the surface to be clean to remove all the dirt, oil, and dust. Repeat this procedure several times depending on the condition of the surface to be cleaned.

 

- Elastomeric Protective Coating

Electrical systems may transform into an undesired conductive structure leading to adversities, electrical leakage, loss, or failure when exposed to external effects (i.e., dust, dirt, moisture, wetting). FlyArt electrical insulation spray is applied to the area or surface that needs to be insulated to obtain a bright, slippery and wetproof coating. This coating insulates all electrical surfaces for full protection.

 

-          It prevents corrosion, rusting, dusting and moisturization by breaking contact with atmospheric air.

-          Prevents electrical arcs in transformers.

-          Fully protects insulators, extending their service life, ensuring continuous operation.

-          Protects electrical panels against external weather effects.

-          It may be used in all types of industries, protecting all power and signal transmission components of electrical and electronic cards.

This fast drying, flexible and transparent elastomeric coating is used for protecting electrical circuits. It is manufactured for professional use only and meets the requirements of most international standards.

  • It dries to a touchable finish in a noticeably short time, improving the efficiency of application processes at a low cost.
  • It maintains its transparency and high stability even when exposed to UV rays.
  • It provides a high level of protection in humid environments and it is resistant to molding.
  • It is capable of adhering to various substrates perfectly.

 

Instructions of Use

It can be applied by spraying, brushing, or dipping. Thickness of the coating might differ depending on the method of application (typically between 25-75 microns). This product should not be applied when the temperature is below  0°C or relative humidity is higher than 75%. An adequate quantity of product must be used as in all other solvent based protective coating products.

 

Clean the substrate thoroughly with FlyArt Electrical Surface Cleaning Spray before starting the coating process. This cleaning is essential for effective adhesion of the protective coating to the substrate. Furthermore, all residues should also be cleaned as they might cause wear if left on the substrate

WhatsApp ile iletişime geç